2009 CASE IH 8120

2009

CASE IH

8120

4 167

Y9G207204

3 212

Occasion

E00674215

This is a Consignment Unit - No Trades Allowed, 2009 Case IH 8120 combine, 4166 engine hours, 3213 separator hours, Extended wear rotor, rotor cage, with extended wear cone, 2 round bar concaves (1L & 2R), 2 large wire concaves (1R & 2L), Large skip wire grates, 1 5/8" pre-sieve, 1 1/8" upper sieve, 1 1/8" lower sieve, 520/85R42 front Firestone duals @ 70%, 2-speed power rear wheel drive, 600/65R28 rear Firestone tires @ 65%, 350 bushel grain tank with manual fold extensions, 24 foot unload auger, Has been converted to 40 knife Mega-Cut chopper, Guidance complete - WAAS accuracy - with Pro 700 monitor, front HID lights, Deluxe cab, Has HD lift cylinders, A/C blows cold, Runs and starts good, Minor engine blow-by, Local customer has owned it since 2019 - most of the service work done by Luverne-MN location, Current customer is the 3rd owner, Lots of service order history available,,,Recent work includes: Reman feederhouse drive gearbox installed end of fall of 2025, 2 seasons on new extended wear transition cone & new rotor cage vanes, 2 seasons on new pre-sieve, 2 seasons on elevator chain - drive sprocket & bearings - drive chain, 2 seasons on new extended wear bubble up auger & Ihle tube liner kit, Vertical unload auger liner & elbow & unload tube replaced end of 2024 season, Tailings processor housing has been reinforced and welded, Liner kit has been installed under grain tank cross augers, LH outer dual rim has been repaired, Liner kit has been installed in clean grain auger housing,,,Below is a list of items needed to be address:, Elevator boot has hole worn through, RH rear sieve frame rotation bearing needs to be replaced, LH rear chopper pan bolt is broken - needs releveled, Chopper pan bent - stationary knives do not swing up, Chopper knives flipped & some replaced, Basic service: Engine oil & filter - engine air filter & cab filters blown out, Some minor leaks/weeping by oil coolers, LH flasher light housing needs secured, Front RH beacon does not spin, Rear RH panel latch adjusted, Tailing processor safety shield missing, On the lot and available for viewing! Call the store @ (for any additional questions! Mechanical Condition: FAIR Monitor ROPS

Broyeur de paille

Eparpilleur de menues-pailles

Corn/Beans

Oui

Oui

Oui

Oui

Oui

Duals

600/65R28

520/85R42

Oui

Oui

4WD